|
|
Post by tony31 on Sept 14, 2016 19:21:29 GMT 10
Hi, I'm hoping someone on here has the castle lock nut special tools for torquing up the 3 frame adjuster bolts. If you have them and are willing to help I would be very grateful.
Regards
Tony
|
|
madadz
Living Legend
The Bandit
Posts: 1,905
|
Post by madadz on Sept 15, 2016 10:27:15 GMT 10
I made some up impact sockets.
|
|
|
|
Post by tony31 on Sept 15, 2016 16:46:03 GMT 10
Did they have the offset tab for the torque wrench? If not how did u prevent the adjuster bolt from turning when torquing the lock nut?
|
|
|
|
Post by tony31 on Oct 12, 2016 12:19:39 GMT 10
Does anyone have a socket for the head stem nuts?
|
|
|
|
Post by kenmoore on Oct 13, 2016 17:37:21 GMT 10
I used an old dirt bike shock adjusting spanner when I did mine.
I went by feel and didn't use a torque wrench either.
No probs so far, just make sure the bars fall easily to the left or right by using a headstock stand to raise the wheel off the ground.
You don't want the bearings too tight !
|
|
|
|
Post by tony31 on Oct 13, 2016 23:30:18 GMT 10
Just for the record, I end up using a 42mm (1"11/16 works also) 12 point socket and torqued the bearings to the specified 25nm in the Honda manual. All done now.
Thanks
|
|
